News:

Reminder to CLC members, please make sure that your CLC number is stored in the relevant field in your forum profile. This is important for the upcoming change to the Forums access, More information can be found at the top of the General Discussion forum. To view or edit your profile details, click on your username, at the top of any forum page. Your username only appears when you are signed in.

Main Menu

41 Cad Mod6219 - fuel filler tube assembly

Started by alan e feltham, April 10, 2006, 12:52:21 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

alan e feltham

April 10, 2006, 12:52:21 PM
I do not find an illustration in any of the manuals...1)How does the welded tab on the fuel filler neck (at top) fasten to the rear fender? Does a bolt go through the fender directly into the captive nut in the tab or is there another mounting bracket? Any rubber bushings? 2)The master chassis manual references a fuel vent hose - is that correct? if so where is it?/ thanks

Doug Houston

#1
April 10, 2006, 05:18:23 PM
The tab on the filler neck has the captive nut, as you say. The tip fin housing that covers the filler neck has a sheet metal base piece that bolts to the top of the fender. There is a gasket between the fender and that base piece. You will find a hole in the base piece where a bolt (1/4-20 thread?)  goes through and picks up the tab on the filler neck.The bolt hole is immediately forward of the filler neck hole.  That, and the coupling hose at the tank are the support that the filler neck has. The filler cap is vented, and there isnt a vent hose on the tank.
Print
Go Up Pages1
User actions