News:

Please note that the Forums will be in Maintenance Mode, i.e. not accessible, this coming Wednesday, May 15th, This is to make backups and carry out the changes to make the forums only allow posting by CLC members. The start of the transition is planned for around 9 a.m. EDT, and is expected to last between four and eight hours.

Main Menu

Speedometer continued i

Started by Coral58, January 15, 2024, 10:29:11 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Coral58

Hi,me again. I've just removed the inner speedometer cable from my 58. I was fortunate enough to remove it from under the dash. I removed the cover under the steering column,here I could see the end of the cable threaded to the lower rear of the gage cluster. By removing two heat and defrost ducts and bending down a third one, I could undo the cable and turn it down enough to remove the inner cable.
It appears in n good condition, no worn areas, but some dry tacky areas at the dash end. Tomorrow I plan to decrease lube it well and reinstall.     
I'd like to test it with out moving to car,which direction should it turn, can I put the trans end  into a low speed  drill. All of your previous comments have been very helpful.     Ivan

The Tassie Devil(le)

In a word, Yes.   You can remove the end from the Transmission, and then rotate the gear with a battery drill.   But, the drill has to be in reverse rotation.

Bruce. >:D
'72 Eldorado Convertible (LHD)
'70 Ranchero Squire (RHD)
'74 Chris Craft Gull Wing (SH)
'02 VX Series II Holden Commodore SS Sedan
(Past President Modified Chapter)

Past Cars of significance - to me
1935 Ford 3 Window Coupe
1936 Ford 5 Window Coupe
1937 Chevrolet Sports Coupe
1955 Chevrolet Convertible
1959 Ford Fairlane Ranch Wagon
1960 Cadillac CDV
1972 Cadillac Eldorado Coupe

Lexi

Quote from: Coral58 on January 15, 2024, 10:29:11 PMHi,me again. I've just removed the inner speedometer cable from my 58. I was fortunate enough to remove it from under the dash. I removed the cover under the steering column,here I could see the end of the cable threaded to the lower rear of the gage cluster. By removing two heat and defrost ducts and bending down a third one, I could undo the cable and turn it down enough to remove the inner cable.
It appears in n good condition, no worn areas, but some dry tacky areas at the dash end. Tomorrow I plan to decrease lube it well and reinstall.     
I'd like to test it with out moving to car,which direction should it turn, can I put the trans end  into a low speed  drill. All of your previous comments have been very helpful.     Ivan


 :)   Clay/Lexi