**SOLD** Huge inventory of 1958 parts

[Mitchell CLC# 22427]

Gents,
I sadly sold my last 1958 Cadillac over a year ago (I have owned 3 1958s over the years), and am left with quite a large inventory of spare parts that the last buyer surprisingly wasn't very interested in.  I am looking to sell the parts ideally together as 1 big LOT, as it would be a ton of time to individually ship them. 

With this in mind, I'm asking $600 for everything below, PLUS shipping of your choice.  Of course, local pickup in NE FL is fine.  I think it is very competitively priced, but would still consider an offer for the whole lot from a fellow CLC member.   

Here is a list of the parts my friend made, who is a Cadillac restoration expert. It should be quite accurate. Unless noted, parts are all used:

Convertible top motor-rebuilt
2 dash heater control units-good condition
Stainless hood V
2 Upper rear door trim pad anti chaff moldings
Right and left door trim pad chrome moldings
Back up light lens
2 bullet moldings for rear taillights, no chrome plating
4 Wiper arms
Transmission linkage shield
Antenna lead, short about 15” long
Heater Ranco valve, used, needs rebuilding
Engine vacuum pump, attaches to oil pump, used
Miscellaneous electrical relays, connectors and wiring
1958 standard wheel cover
2 washer jars with tops and extra pump parts
Left-right-center A/C dash doors with 2 deflectors
2 sets of brake shoes new
Battery hold down, new
Wiper coordinator, used
Wiper motor with coordinator, used
Electric door lock solenoid
Glove box trunk release switch
Distributor cap for 3-2 bbl carb. Engine
Grill bullets, some gold and some natural
Left and right headlight doors- no cracks   
Left and right door edge guards used
Autotronic eye complete, need rebuilding
Trunk gold V-some studs missing
Eldorado trunk letters-fair condition
2 horn rings
Wiper and washer switch with cable and mounding-good condition
Wiper molding w/o switch and cable
Dash molding across dash above glove box to right side
Miscellaneous widow switches including driver side
3 P/S pumps
1 steering gear box
One radio with four extra tubes
Lighters complete with rear seat plates and ash trays Some lighters incomplete
Below rear bumper chrome strips. Some missing studs
Some ¼ panel chrome strips.  Some missing studs
Generator non-a/c with proper p/n and date code
Starter with correct p/n and date code
2 new oil filter cartridge
Tri-power air cleaner-aftermarket
Brake booster rebuild kit
Trunk weather strip-new
Front suspension rebuild kit w/o ball joints
Distributor vacuum advance for tri-power
Vacuum tank
Standard distributor cap for non-tri-power
One Delco ignition coil-U505 p/n 12337166
One Delco distributor rotor-D426R, p/n 12338671
One Delco ignition point set-D106P, p/n 12338659
2 turn signal flashers- Tridon Stant 550
One Delco thermostat-131-6, p/n 3043320
3 Delco radiator cap- RC6, p/n 850800
2 Eldorado trunk jacking instruction and storage instructions
1 metal vacuum tee from eng. to wipers, washers, anti-stall diaphragm
One set of convertible top boot insulators-new 

Can call/text cell at 904-299-5326 during sane EST hours

[fishnjim]

I'm only interested in a few items, not enough to take the whole lot.   My shelves are full no room for more.  If it doesn't sell, and you decide to part, repost or let me know.   The swap meet guys should take.

Any '58 coupe sheet metal?   

[Mitchell CLC# 22427]

Price reduced to $800 (or best offer) for the entire lot, to help me make some room.
While no sheet metal, there is a lot of rare/hard to find stuff here....

[Dexfoster]

Might you have a Continental kit?dexfoster

[Mitchell CLC# 22427]

Might you have a Continental kit?dexfoster

Unfortunately - no.  Just what's in the list

[Mitchell CLC# 22427]

Bump.  Willing consider offers to find a new home

[Mitchell CLC# 22427]

Price lowered to $600 (plus shipping or local pickup). This is a great inventory of 1958 parts.

[Mitchell CLC# 22427]

Bump.  Still available.  Located close to Amelia Island, if anyone going to Concours in 2 weeks.

[Mitchell CLC# 22427]

BUMP

[Mitchell CLC# 22427]

Still available.  Great collection of parts.  Hoping to make room and help out a fellow CLC member, rather than putting on ebay.

[Mitchell CLC# 22427]

Bump... $550 plus shipping or going to ebay next week then scrap.

[Cadillac Nut]

If you get to the point where you are going to scrap it, let me know, I'd buy it for more than you'll get in scrap.  The price now for everything is fair, just shipping is a killer, I"m in Chicagoland.  I have 3 1958s. 

[fishnjim]

Nut, I'm about a days drive to Mitchs.   I don't need all those parts, just a few.
Do you have any '58 parts cars?   I need some sheet metal items.   Maybe we can work something out, 3 ways?   

[Mitchell CLC# 22427]

SOLD