1960s 1960 seville

[Brianlambert]

Can someone help me ID these parts. I'm restoring my 60 Seville and am currently reassembling the interior. I can't find any pictures of them during the disassembly phase. They look like they may be from the interior.
Thanks

[D. Mailan]

Hi Brian,
I am not too sure, I may be wrong.

If I recall correctly some of them attach to the bottom of the seats. The four pieces at the bottom of your picture are to attach the seat track cover. They are clamshell like plastic covers that are attached by two mounts near the seat tracks at the bottom of the seat. 

The two pieces in the middle, I believe are to attach the chrome seat trim at the bottom of the seats. Those pieces would attach to the front of the seat to fasten the chrome piece on.

The two curved pieces in the upper right may be the clips for the same "bottom of the seat" surround trim. Those would most likely be located on the side of the seat.

I am not too sure what the others are. Probably other seat pieces. Hopefully others will chime in.

Best of luck!
Derick

[59-in-pieces]

Brian,

The 4 brackets at the bottom of your pictures are used to attach the "knee" bolsters on the back of the seat backs - one bolster with 2 brackets with the nails for each bolster - for coupes.

Yes the other upper bracket are used to attach the bottom and side moldings on the outside of the seat backs and seat bottom facing the inside of the doors.

I'm tired right now, but I will post some pictures tomorrow that will show you where all the bracket go.


Have fun,
Steve B.

[Brianlambert]

Thank you! The pictures would be very helpful

[59-in-pieces]

Brian - sorry for the R,

One way to start is to hold the side seat trim up to where they go- line up the screw holes with the seat sides and that is where the brackets go.

The first pic is a diagram of the set-up for the bottom mounting brackets, both front and back - AG & AJ.

The second is a pic of the back of the front seat back, showing where the "knee" bolsters attach to the rear of the front seat back - table bracket with the hole in the middle.

The third pic shows the bracket at the corner of the seat bottom and seat back.

The forth pic show the bracket at the front corner of the seat bottom.

The fifth pic shows the slot bracket inside the "knee" bolster into which the "nail" in the table mounting bracket goes in one of the 2 holes and slides along the slot to hold the bolster in place, and the screw at the pointed end of the bolster screws into the inside edge of the seat back above the center arm rest.

The sixth pic is the bracket that goes at the top of the outside edge of the seat back.
I can't be sure of your pics of the 2 upper brackets because of the high gloss black paint, likely they are described above.

Hope these pics help.

Have fun,
Steve B.

[Brianlambert]

Thanks
These pictures are very helpful!!