News:

Please note that, while reinstating users, I have noticed that a significant majority have not yet entered a Security (Secret) Question & Answer in their forum profile. This is necessary for a self-service (quick) password reset, if needed in the future. Please add the Q&A in your profile as soon as possible

Main Menu

1961 390 oil pump drive shaft

Started by dbzsjones, December 29, 2023, 01:18:45 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

dbzsjones

I'm rebuilding a 1961 390 and the shaft between the distributor and oil pump has gone missing.  Is this a standard GM part I can stll buy, or do I need to find a used one?  I'm not having any luck searching for a new one directly.  I greatly appreciate any insight on the best options for finding a replacement.

Clewisiii

"My interest is in the future, because I am going to spend the rest of my life there."  Charles Kettering

Daryl Chesterman

There is one listed for sale on ebay, but it is expensive!!!


Daryl Chesterman

dbzsjones


Clewisiii

I have one in my parts car. But I am in Michigan and it is cold and wet. If you would like it I will try to pull it out over the next couple of days.
"My interest is in the future, because I am going to spend the rest of my life there."  Charles Kettering

Clewisiii

It took some beating. But I got my parts car distributor out.

I sprayed some penetrant in the hole, but I cannot find my large magnet wand. The little one is not strong enough to pull out the drive rod.
"My interest is in the future, because I am going to spend the rest of my life there."  Charles Kettering

Clewisiii

"My interest is in the future, because I am going to spend the rest of my life there."  Charles Kettering

Lexi

Have an extra here that I would part with, but will have to do some research to ensure is the correct one. Potential back up for you, if need be. Clay/Lexi

The Tassie Devil(le)

Having that piece out and easily accessible, would be the best time to craft the mechanical Priming device to rotate the pump.

When I made mine, I had the pump out, and it was easy to hammer the tool into the correct shape.   Using the rod as an anvil.

Inserting the Roll Pin stops the tool from getting caught on the end of the shaft, making it easier to remove following priming.   Plus, it is a good tool for aligning the oil pump with the bottom of the distributor when replacing said distributor.

Bruce. >:D
'72 Eldorado Convertible (LHD)
'70 Ranchero Squire (RHD)
'74 Chris Craft Gull Wing (SH)
'02 VX Series II Holden Commodore SS Sedan
(Past President Modified Chapter)

Past Cars of significance - to me
1935 Ford 3 Window Coupe
1936 Ford 5 Window Coupe
1937 Chevrolet Sports Coupe
1955 Chevrolet Convertible
1959 Ford Fairlane Ranch Wagon
1960 Cadillac CDV
1972 Cadillac Eldorado Coupe

Clewisiii

This parts car has already given up a lot of parts. But I am happy when I find another one that someone can use.

I paid $400 for this at a ghetto garage sale in Lansing Michigan
Cost me $600 to get it home. The first part I took from it was the power steering pump when I broke the back cap on mine.

IMG_20240104_110854066.jpg
"My interest is in the future, because I am going to spend the rest of my life there."  Charles Kettering